Stock column shifters on Broncos have always been troublesome. The stock rods bend causing the neutral gate to go out of alignment making shifting difficult. Sometimes the release pin on the collar eggs out, letting you take the shifter with you! Our 3-speed floor shifters eliminate those problems and make shifting a joy again! Other shifters run your knuckles into the dash, so we shortened the throw 4” and added a 1” offset to the right for extra leg room. Included is the rubber boot, bezel, walnut knob, decal and white fiberglass tunnel cover with screws. Designed to fit a V8, but the rods may be shortened approx. 2.5” by cutting, overlapping and rewelding to fit the 6cyl. May be used with the stock transfer case shifter or match it with our transfer case shifters sold below.