Product Code: 3640

Heavy Duty Motor Mounts Bronco II Ranger V8 302 Conversion

$199.95

Availability: 5 in stock

Purchase this product now and earn 200 DuffBucks!
(9 customer reviews)

 

Our new heavy-duty design replaces the hard-to-find motor mounts necessary for doing a V8/5.0L swap in your 4WD Bronco II or Ranger. These mount a V8 block to the existing cross member utilizing urethane bushings with 9/16″ bolts to reduce engine vibration and engine torquing. They set the V8 up slightly higher than the original engine to make room for the oil pan. The engine cross member must be drilled for the new motor mounts. With the mounts, you receive a diagram showing the location of the new 1/2″ slots. Although every attempt has been made to provide you with the correct locations, there are some variations where the slot may need to be enlarged.

Note: Our motor mounts will likely need slight modifications made to them in order to fit 5.0 blocks made after 1985.

Weight 12.45 lbs
Dimensions 8 × 8 × 8 in

9 reviews for Heavy Duty Motor Mounts Bronco II Ranger V8 302 Conversion

  1. Austin Rogers (verified owner)

    Ordered, shipped quickly, good stuff and great product!!!

  2. Daniel Hoppe

    The mounts are really good quality and heavy duty but they did require some modification to bolt to the block. I had to Dremel one of the bolt holes so the bolt would line up on both sides of the mounts. Also had to notch the Driver side mount. All in all if you’re doing a V8 swap modifying the mounts isn’t hard. We’ll see how it seats on the crossmember soon.

  3. Todd stankey (verified owner)

    Very heavy-duty. The ultimate swap mount

  4. Joseph Jimenez (verified owner)

    Awesome mounts. Got these to swap a 5.0 into my 88 Bronco II. Cant wait.

  5. Vonn Snyder

    Super heavy duty, fit great. One note about it, I have an 01 block from an explorer/mountaineer. The later 5.0/302 blocks have a plug in the block on the driver’s side that causes contact with the upper bracket that bolts to the block. Little bit of clearancing to the bracket and everything worked perfectly. The older 5.0/302 blocks have no issues.

  6. Steve Sodia

    the adapter fit perfect. I am very pleased with the products that you provide.

  7. David ramsey

    They fit with no problems at all. That’s hard to find these day

  8. mike rogers

    Definately heavy duty! I’ll see how they fit when i install the 302!

  9. Christopher Shufelt

    Beefiest motor mounts I have seen. I bet I will rip the frame out of the Bronco before the motor mounts have issues. Thanks for some quality products.

Add a review

Your email address will not be published. Required fields are marked *

Shopping Cart
Scroll to Top